Sherline Direct Cart items: 0  Total: $0.00
1/4" Drill Chuck with two Arbors

Product #: 1072
Price: $57.75

[Add to Wishlist]

In stock
A drill chuck is probably the most important accessory you will need for your lathe. It will enable you to accurately centerline drill, ream, or tap any part mounted on the lathe. The part to be machined is chuck or collet mounted in the headstock. The tool is mounted in the tailstock chuck and fed into the part using the tailstock ram feed. Parts that are going to be mounted between centers can be center drilled this way. Other parts requiring a hole accurately drilled on center can also be machined this way.

The Sherline tailstock chuck P/N 1072 is a precision 3/32″ to 1/4″  3-jaw chuck complete with key. The chuck is fitted with a #0 Morse arbor for use in the tailstock. Also included is a #1 Morse arbor and drawbolt so the chuck can be used in the lathe or mill headstock as well.


  • Chuck Capacity -  1/32″ (.8 mm) – 1/4″ (6.4 mm)
  • Arbor - #0 Morse for tailstock and #1 Morse for headstock
  • Runout - .003″ or less
  • Includes - chuck key, drawbolt+washer and 2 arbors 
NOTE: If runout of less than .003″ amount is required, collets should be used to hold the drill rather than a chuck.
Replacement Parts
11860 - Chuck key, 1/4″ drill chuck
11880 - threaded arbor, #1 Morse taper
11890 - threaded arbor, #0 Morse taper
11900 - 1/4″ drill chuck body
30880 - 1/4-20 x 5″ drawbolt with centering washer (for #1 Morse arbors)

Download PDF Instructions

Instructions PDF Download


May we also suggest
Individual WW Collets
Individual WW Collets
Mill Collets
Mill Collets


Site Map